Bright Ideas
Spaces that adapt to the people using them.

Home and building automation for hotels, homes, offices and venues. Light, climate and blinds from one place.

Start with hotels

DALI lighting control

The standard for controlling light in offices, hotels and buildings. We design it, supply it and commission it.

What DALI is

What DALI is

DALI (Digital Addressable Lighting Interface) is an open international protocol, defined in IEC 62386, for controlling lighting. A two-wire bus carries digital commands to each fitting, and each one has its own address.

This makes it possible to dim, group and programme scenes without rewiring. And it works both ways: every device reports its status and flags faults, which is key to maintaining a building.

DALI-2 is the current version. It certifies that devices from different manufacturers work together and, for the first time, includes controls: push buttons, sensors and panels. D4i adds energy and diagnostic data to the fitting, plus power to connect sensors directly.

The devices are made by Sunricher, one of the leading manufacturers of lighting control. We show them with their brand and original codes, so you can check every datasheet.

See all the protocols we use

How a DALI line works

64Devices per lineEach DALI line supports up to 64 control gear, each with its own address.
16 + 16Groups and scenesFittings are organised into 16 groups and 16 scenes can be recalled.
2 wiresNo polarityThe control bus is two polarity-free wires that can run alongside the mains.
300 mPer lineUp to 300 m per line; up to 600 m with a repeater.

Device types

DT6Single colour

Dimming of single-colour fittings and strips.

DT7Switching

Relays to switch loads without a DALI input.

DT8Colour

Tunable white (Tc), colour coordinates (XY) and RGBWAF.

D4iSmart luminaire

Energy and diagnostic data, and power for sensors.

What our devices bring

NFC configuration

Programmed by holding a phone close, even with the fitting unpowered. Replacing a faulty unit takes seconds.

Flicker-free light

±1 % current accuracy, dimming down to 1/1000 and no flicker on camera.

Constant lumen and corridor mode

The fitting compensates for ageing (CLO) and corridors dim to minimum when empty (CD).

Circadian rhythm

Masters adjust colour temperature through the day to follow people’s rhythm.

Energy in view

Management software with consumption analysis, scheduling and fault alarms.

Integration

Gateways to KNX, Zigbee, Bluetooth, RF, Ethernet and MQTT.

Solutions

Small spaces

A single DALI line is enough for fewer than 64 fittings: a master, push buttons, sensors and drivers. Offices, shops or a hotel floor.

Buildings with KNX

A KNX–DALI gateway integrates lighting into the building’s KNX installation, programmed with ETS.

Upgrades without rewiring

Zigbee, Bluetooth or RF to DALI converters control an existing DALI installation without opening ceilings.

Large buildings

Several networked IoT gateways, with central control, scheduling and energy analysis.

Tell us about your project.

WhatsAppEmail